Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing geometry parameters with matlab after embedding symmetry planes.

Posted Oct 17, 2010, 5:50 a.m. EDT 0 Replies

Carola Geiger
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi!

I am using COMSOL 3.5a with matlab interface. Since my structure is symmetrical, I am using symmetry planes for only calculating 1/4 of the structure. I now want to change the geometry of my initial structure using the matlab interface. Before I embed the symmetry planes, this is still possible, however afterwards, the whole structure is saved in only one mphm file, when saving the model as an .m file. Is there a possibility to change the initial structure, even at this point?

Best regards,

Carola Geiger
0 Replies Last Post Oct 17, 2010, 5:50 a.m. EDT
COMSOL Moderator

Hello Carola Geiger

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content