Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"Cantilever Design in Comsol"

Please login with a confirmed email address before reporting spam

Hi all,

I have been trying to design the cantilever beam in 3D MEMS module,
but, an error crops up i.e:

"No convergence achieved..", when I use coarse mesh.

Is there a problem with the amount of force I apply at the edge or mesh resolution or something else?


**Also, How do I vary the thickness and observe the respective change in displacement for the same load??

Can somebody help me, by giving a detailed stepwise procedure to design a simple 3D cantilever beam or give a link to a ppt or pdf which will be useful to me..

Please Reply at the earliest...
Thanks.

0 Replies Last Post Oct 6, 2009, 11:19 a.m. EDT
COMSOL Moderator

Hello ADITYA MATHAD

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.