Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Connection between 2 shells

Please login with a confirmed email address before reporting spam

Hi,
I have a very simple question that I am struggling with it for a while. I have 2 shell plates modelled in 3D and parallel to each other. One of the shell plate has a offset from the other one with (Thk1+Thk2)/2 which means considering the thickness 2 surfaces should touch each other. How can I define a contact between them? In other commercial software this usually can be done with 2 clicks but doesn't seem so easy in Comsol

1 Reply Last Post Feb 18, 2017, 1:51 p.m. EST
COMSOL Moderator

Hello Siavash Shoja

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 8 years ago Feb 18, 2017, 1:51 p.m. EST
I've a similar problem. Did you figure something out Siavash?
I've a similar problem. Did you figure something out Siavash?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.