Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

What is the best way of meshing a comb shaped capacitor with small dimensions

Please login with a confirmed email address before reporting spam

I would like to simulate couple of comb shaped capacitors with different number of fingers each time.
The capacitor is placed on the top of a 1mm hydrogel layer.

For meshing, sometimes the Physics-Defined do the job. However, many times it causes me troubles and shows up errors even after increasing the fineness.

I would like to ask for recommendations or insights on the best way for meshing this structure.

My comsol model file is attached.


0 Replies Last Post Jun 14, 2016, 3:04 p.m. EDT
COMSOL Moderator

Hello Haneen Alsuradi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.