Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
hai friends
Posted Jun 29, 2016, 8:37 a.m. EDT Fluid & Heat Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
Can anyone help me for designing a lid driven cavity flow in 2D or 3D in comsol? Since am new to this field, i couldnt able to compute in solving the problem because of errotic message showing linear iterations failed to converge.
1 Reply Last Post Jun 29, 2016, 8:52 a.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hello Sudha,
A common mistake made with interior flow problems is to forget to set a gauge pressure somewhere. Without one, the problem is not well-posed (no unique pressure distribution). So apply a pressure point constraint in one corner of your geometry and see if that's the only problem with your set-up.
Best regards,
Jeff
A common mistake made with interior flow problems is to forget to set a gauge pressure somewhere. Without one, the problem is not well-posed (no unique pressure distribution). So apply a pressure point constraint in one corner of your geometry and see if that's the only problem with your set-up.
Best regards,
Jeff