Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Membrane valve
Posted Aug 12, 2016, 1:49 a.m. EDT Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to simulate membrane valve for water flow with a help of FSI module.
On the attachment you can see the membrane (bottom part) and the constraint (upper part) with channels.
If I simulate valve without channels filling, there is no problems: by means of contact pair between lower and upper part I can open and close the membrane. But when I'm trying to add fluid into channels, I can't apply the Fluid-Structure interface boundary because of the contact pair.
And so the question: how to simulate filled valve opening?
For example: one channel is inlet with 1 Bar water flow, the other - with 0 Bar and the membrane is opening downstairs.
Best wishes,
Vladimir
Attachments:
Hello VVE
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.