Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Geometry Deformation in Heat Transfer with Phase Change Module

Please login with a confirmed email address before reporting spam

Hi all
I am doing a project using heat transfer with phase change module, which is a sublimation process. But I met a difficulty about simulating the interface change using Deformed Geometry module. Could anyone tell me how to simulate the material removal velocity? I will be appreciated if someone can help me.
Thanks so much!
Jifeng

0 Replies Last Post Aug 17, 2016, 9:41 a.m. EDT
COMSOL Moderator

Hello Jifeng Ren

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.