Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
3D Induction heating of a cylinder
Posted Aug 22, 2016, 2:17 p.m. EDT Low-Frequency Electromagnetics, Heat Transfer & Phase Change, Geometry, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 5.2, Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
I am trying to simulate the induction heating of a cylinder in 3D, using an imported coil with quite a complicated geometry. The problem is, that every time I try to solve it, COMSOL Multiphysics gets stuck after analysing the coil geometry. I also tried to solve easier models with just a helix as a coil, but when I added an air domain around the model it did not work either. Without the air it worked, but this will not result in any induction heating in the cylinder of course. The only node I added to the model so far (because I wanted to keep it simple at the beginning) is the coil node, with the "single conductor" option. Has anybody had a similar problem or maybe an idea what I did wrong?
I added the model below, it is in german, but I think the simbols are still the same.
I hope somebody may help me!
BW Margit
Attachments:
Hello Margit Kranner
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.