Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D Initial Conditions

Please login with a confirmed email address before reporting spam

Hello Everyone!

I am working on adsorption heat pumps where there are 2 stages called 'adsorption' and 'regeneration'.The
initial conditions of regeneration phase is the ending conditions of adsorption phase. Since I am working on 2D model, somehow I have to put these 2D data as initial condition (temperature profile or concentration profile) and I couldn't figure out how to it.
Any ideas?
Thanks in advance.

1 Reply Last Post Nov 7, 2016, 12:32 p.m. EST
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago Nov 7, 2016, 12:32 p.m. EST
Hello Talha,
It's in the study step settings that you specify where the initial values for the dependent variables are taken from. See Reference Manual, version 5.2a, page 921 and following. All manuals are accessed through File > Help >Documentation.
Best,
Jeff
Hello Talha, It's in the study step settings that you specify where the initial values for the dependent variables are taken from. See Reference Manual, version 5.2a, page 921 and following. All manuals are accessed through File > Help >Documentation. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.