Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Averaging multiple cut line 3D

Please login with a confirmed email address before reporting spam

Hello everyone,

I am trying to define multiple cut lines 3D in a 3D geometry in height and take the average of them. Meaning, if I have defined 3 lines then take the average of all of them and represent them in only 1 line.
What is the best way to do so without outputting the results separately and take the average manually?

Thank you for your help.

1 Reply Last Post Feb 1, 2017, 9:45 a.m. EST
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago Feb 1, 2017, 9:45 a.m. EST
Hello Arsha,
You could use Component Couplings of the Linear Extrusion type to pass the information from 2 of the lines to the third.
If you have not used Component Couplings before, you'll want to read the section on them in the COMSOL Multiphysics Reference Manual, version 5.2a, page 289 and following.
Best,
Jeff
Hello Arsha, You could use Component Couplings of the Linear Extrusion type to pass the information from 2 of the lines to the third. If you have not used Component Couplings before, you'll want to read the section on them in the COMSOL Multiphysics Reference Manual, version 5.2a, page 289 and following. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.