Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Geometry

Posted May 5, 2017, 6:35 p.m. EDT 1 Reply

André Ricardo Panesi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How to modify the block geometry, for example, by transforming the square face into round face?
1 Reply Last Post May 16, 2017, 6:22 a.m. EDT
Lars Gregersen COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago May 16, 2017, 6:22 a.m. EDT
Hi

This is difficult without the Design Module. If you have the Design Module you can use loft to blend between shapes:

www.comsol.com/blogs/introducing-the-design-module/

--
Lars Gregersen
Comsol Denmark


How to modify the block geometry, for example, by transforming the square face into round face?

Hi This is difficult without the Design Module. If you have the Design Module you can use loft to blend between shapes: https://www.comsol.com/blogs/introducing-the-design-module/ -- Lars Gregersen Comsol Denmark [QUOTE] How to modify the block geometry, for example, by transforming the square face into round face? [/QUOTE]

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content