Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

electmagnetic wave mode two port problem.

Please login with a confirmed email address before reporting spam

Hi

I used to two port in the electmagnetic wave mode.
but i have a one problem.


first floor is metal.
Divide the metal in half.
left of the metal is port1 and right is port 2.
incidence angle of the port1 is start : 0
step: pi/40
stop:pi/2-pi/40
, incidence angle of the port1 is start : 0
step: -1*(pi/40)
stop: -1*(pi/2-pi/40)
now i have quastion.
it is correct that combine result of study1 and result of study2 ???
or it is correct that combine setting port 1 and port 2 to one file ???

0 Replies Last Post May 30, 2017, 10:37 a.m. EDT
COMSOL Moderator

Hello Kyushic Shin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.