Discussion Forum

Forum Home

New Discussion

Note: This discussion is about an older version of the COMSOL Multiphysics^® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Two parameters sweep and plot

Posted Mar 9, 2011, 8:12 a.m. EST RF & Microwave Engineering Version 4.1 1 Reply

J. Zhang

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, all

I use two parameters sweep in comsol 4.1 to get a function of transmission efficiency vs period and depth of my model. The outer sweep is depending on depth and the inner sweep is depending on period, each of the two parameters is correspond to a transmission efficiency. I want to make the depth as x axis,period as y axis, and efficiency as z axis.

How can i obtain this figure in COMSOL? Or can i get a data set with those parameters and efficiency?

Thanks.

1 Reply Last Post Mar 9, 2011, 11:07 a.m. EST

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Hi

I'm not sure you can within COMSOL GUI, certainly within Matalb, but otherwise dump the values into some tables and get the raw data into another programme (worst case EXCEL ;) by the way there is an option to transpose a 2D table, then you could perhaps add several layers of 2D tables plots but I believe it must be set up manually

--
Good luck
Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL^® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Discussion Forum

Two parameters sweep and plot

Suggested Content