Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to simulate a charge-discharge cycle into a tank?

Posted Aug 30, 2017, 3:03 p.m. EDT Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Modeling Tools & Definitions, Parameters, Variables, & Functions 0 Replies

Hernán Felipe Garrido Pulgar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello! I´m tryng to simulate a charge-discharge process into a tank, but a I dont know how to reverse the boundary conditions, for example, change the upper fluid flow that is entering in the tank (charge), for a lower fluid flow that enter in the tank after 3600 seconds (discharge), when charge process finish. How can you vary the boundary conditions whith time? Thank you very much!
0 Replies Last Post Aug 30, 2017, 3:03 p.m. EDT
COMSOL Moderator

Hello Hernán Felipe Garrido Pulgar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content