Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Need help connecting points automatically with changing parameters
Posted Mar 25, 2018, 8:42 p.m. EDT General, Simulation Apps, Geometry Version 5.3a 1 Reply
Please login with a confirmed email address before reporting spam
I am attempting to change the height of a structure using parameters. The structure is very angular, and therefore when the height is changed the lines that connect the base to the top become either not long enough, or too long. In addition, the lines that connect the base and top are no longer at the correct angle with varied heights. Is there a feature that will allow for the lines to constantly snap the base to the top of the structure when the height is changed parametrically? (The lines that are used as connectors are classified as bezier polygons).
Please login with a confirmed email address before reporting spam
Hello William,
I am not sure I fully understand your question, but you may be looking for the "lofting" feature of the Design Module, see https://www.comsol.com/design-module .
Best regards,
Jeff
-------------------Jeff Hiller