Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Apply AC Signal to a geometry

Posted Jun 30, 2018, 1:41 p.m. EDT Electromagnetics, Low-Frequency Electromagnetics Version 4.3b 0 Replies

Nikhil Valsan Kulangareth
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I have created a cube and I have to find voltage variation at differnet faces when applied an ac signal to one of its faces. I tried with one face of cube delivered with DC voltage and another face as ground. But I am confused how to do the same when appled with ac? Could anyone help.

Thanks in advance

Nikhil

0 Replies Last Post Jun 30, 2018, 1:41 p.m. EDT
COMSOL Moderator

Hello Nikhil Valsan Kulangareth

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content