Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat transfer from LIQUID to SOLID

Posted Jun 11, 2011, 1:13 a.m. EDT Heat Transfer & Phase Change Version 4.0a 1 Reply

Dogan Sinar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hello,

I have a simple set up where hot air is flowing into a metal cylinder with a closed end. There are two hole at the side walls near the end of this cylinder, these are for the outlet. Whatever I do, I don't seem to have heat transfer from hot air to this metal cylinder.

When I set air cooler then the metal, I do get heat transfer. But not vice versa...

Any help would be greatly appreciated, thank you in advance

Regards,
Dogan Sinar
1 Reply Last Post Jun 12, 2011, 4:56 p.m. EDT
John
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jun 12, 2011, 4:56 p.m. EDT
There have been quite a few updates to the heat transfer model since 4.0 was introduced.

Can you upgrade from 4.0a to 4.2 ? Not to say that will cure your problem, but at least you'll know you are using the most up-to-date formulations.

Regards, John
There have been quite a few updates to the heat transfer model since 4.0 was introduced. Can you upgrade from 4.0a to 4.2 ? Not to say that will cure your problem, but at least you'll know you are using the most up-to-date formulations. Regards, John

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content