Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Geometry problem

Posted Jul 8, 2011, 7:48 a.m. EDT Version 4.0a 2 Replies

JiYoung Park
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

my geometry is block, 1[cm]*1[cm]*30[nm](height) : joule heating problem

The problem is that i can't mesh the geometry because it is too thin.

Is there any method to solve this problem?

Thanks,

any comments will be appreciated
2 Replies Last Post Jul 9, 2011, 12:20 p.m. EDT
Alex Edelman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jul 8, 2011, 9:42 a.m. EDT
I've had some success on domains like this by creating a 2D mesh on one of the faces, refining as necessary, then sweeping it to the opposite face.
I've had some success on domains like this by creating a 2D mesh on one of the faces, refining as necessary, then sweeping it to the opposite face.
JiYoung Park
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jul 9, 2011, 12:20 p.m. EDT
Many thanks!!

Many thanks!!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content