Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat transfer module

Posted Apr 12, 2019, 10:09 a.m. EDT Heat Transfer 0 Replies

Gauthier Humblet
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Good day everyone,

I am currently working on a heat transfer problem in COMSOL. Here is my problem:

https://www.engineersedge.com/heat_transfer/conductive_heat_transfer_pipe_13841.htm

Basically, in my boundary conditions of my model I put the temperature T1 and I have a heat flux of 37 kW going out of my cylinder from T2. The goal is to calculate T2 by imposing T1 temperature and the power of 37kW.

My question is: how to put as a condition the 37 kW crossing the section T1-T2 and going out of my cylinder?

Thank you for your answer.

Kind regards,

Gauthier.

0 Replies Last Post Apr 12, 2019, 10:09 a.m. EDT
COMSOL Moderator

Hello Gauthier Humblet

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content