Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Regarding Mesh formation

Posted Jun 3, 2019, 5:58 a.m. EDT 1 Reply

Priyank Agarwal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How to create a mesh in nanolevel layer of a structural material i am analysing?

1 Reply Last Post Jun 3, 2019, 6:43 a.m. EDT
Aashish Sah
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago Jun 3, 2019, 6:43 a.m. EDT

You can try different options for mesh formation. You can start with Physics-controlled mesh from sequence type and then choose Normal element size. If you are not satisfied with your results, then you can choose the element size to be finer.

If none of them works then you can manually define your mesh by selecting user-defined mesh under sequence type. This will require some knowledge on mesh creation, following the documentation will be helpful.

You can try different options for mesh formation. You can start with Physics-controlled mesh from sequence type and then choose Normal element size. If you are not satisfied with your results, then you can choose the element size to be finer. If none of them works then you can manually define your mesh by selecting user-defined mesh under sequence type. This will require some knowledge on mesh creation, following the documentation will be helpful.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content