Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Switching boundary

Posted Aug 21, 2019, 6:34 p.m. EDT Fluid & Heat, Chemical Version 5.2a 0 Replies

Haris Khan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone...

I am doing time dependent simulation on a falling film reactor. The study is basically on the mass transfer of gas into the liquid falling film. In my study the liquid film is flowing on the outerside of capillary at some constant flow rate and on the other hand the gas is stagnant. The liquid is constantly circulating within the reactor. The problem which I faced is: How I can coupled the outlet concentration to the inlet concentration. Actually I am simulating until the equilibrium pressure is obtained.

Does anyone know how can I do this. Any help would be very appreciated !

Thanks a lot.

Haris Khan

0 Replies Last Post Aug 21, 2019, 6:34 p.m. EDT
COMSOL Moderator

Hello Haris Khan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content