Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Implementing General Navier Boundary Condition for droplet generation in microchannels

Please login with a confirmed email address before reporting spam

Hello everyone!

I would like to know how can I change/adapt the pre-existing boundary conditions on COMSOL to this General Navier Boundary Condition (GNBC) as I am working with a moving contact line problem (a water droplet phase on a continuous oil phase).

I have seen that it is possible can use the 'Coefficient From Partial Differential Equation' to address this issue, but I am not sure how to do so. For example, how and where should I input the variables?

Thanks in advance,

André


0 Replies Last Post Sep 2, 2019, 12:39 p.m. EDT
COMSOL Moderator

Hello André Moura

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.