Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Continue an Interrupted Simulation On Cluster Computing

Posted Nov 5, 2019, 11:19 a.m. EST Computational Fluid Dynamics (CFD), Microfluidics Version 5.4 0 Replies

Hossein Ahmadian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Everyone,

I have a set of relatively large time-depenent simulations. The problem is that my university walltime limit does not allow for more than two days. Therefore, I need to find a way to continue my simulations after each walltime limit. I can open the recovery files and the solution. However, I am not able to find the "Continue" anywhere, only "Compute" which will initiate the simulation from the begininng.

Is the Continue capability avaialble for time-dependent studies on cluster computing? and If so do I need to change any settings somewhere before my first simulation? BTW I am using v5.4

Thanks,

0 Replies Last Post Nov 5, 2019, 11:19 a.m. EST
COMSOL Moderator

Hello Hossein Ahmadian

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content