Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Remeshing problem?
Posted Nov 29, 2019, 10:52 a.m. EST Computational Fluid Dynamics (CFD), Mesh Version 5.4 0 Replies
Please login with a confirmed email address before reporting spam
I am simulating a nanoparticle "sphere" moving through a creeping fluid flow. Two physics are activated : 1- creeping flow 2- moving mesh ALE
The ALE Boundary conditions are : - Prescribed mesh displacement : 4 walls of the nanochannel - Free deformation: Both the fluid and solid domains - Prescribed mesh velocity: Boundaries of the sphere solid domain
The Creeping flow Boundary conditions are : - Walls with No-slip Bcs and Zero transnational velocity "Fixed wall": The side walls of the nanochannel - Open boundaries: the inlet and outlet wall of the nanochannel - Walls with No-slip Bcs and transnational velocity "Automatic from frame": Boundaries of the sphere solid domain
The problem i have that, there is no re meshing is taking place, Although i activated the automatic remeshing button, and the mesh is highly distorted and stretched as shown in the attached images. Any help to figure out the cause of this problem?
Hello Osman Omran Osman Mosa
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.