Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Chladni Plate Simulation App - How to change it to visualize a continuous range of frequencies

Gabriel Henrique Armando Jorge

Please login with a confirmed email address before reporting spam

Hi!

I have just found this simulator for Chladni Plates: https://br.comsol.com/model/chladni-plate-67591

I have no big simulation expertise, and my experience with COMSOL is relatively new. I'm trying to run this simulation for a full, continuous, range of frequencies, not only the eigenfrequencies. Is it possible? Where can I make changes to make it possible?

My ideia was to create a simulation like this one here: https://www.youtube.com/watch?v=ZWm6DTBhbcI

Thanks a lot!


1 Reply Last Post Dec 9, 2019, 5:17 a.m. EST
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago Dec 9, 2019, 5:17 a.m. EST
Updated: 5 years ago Dec 9, 2019, 8:16 a.m. EST

Hi,

You need to run a frequency sweep, using a Frequency Domain study. Then, plot using an animation.

It is probably easier to start from a fresh model than from the app, since the latter contains a lot of specialization.

Regards,
Henrik

-------------------
Henrik Sönnerlind
COMSOL
Hi, You need to run a frequency sweep, using a Frequency Domain study. Then, plot using an animation. It is probably easier to start from a fresh model than from the app, since the latter contains a lot of specialization. Regards, Henrik

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.