Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Showing boundary not use for meshing and solving in result graphics
Posted Mar 25, 2020, 12:34 a.m. EDT Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
I created a simple beam bending model as attached to experiment ways to meet the goal. There is a rectangle beneath the free end of the beam. I used "Virtual operations->Igonore Faces" with "ignore adjacent edges and vertices" unchecked to hide it from meshing.
The edges of the rectangle are shown in the result plots. Is it a correct approach? Is there any simpler method? How about for an 3D/solid oject?
It seems that the solver has to run again to see a newly added rectangle.
Thank you.
Attachments:
Hello Panson Poon
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.