Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Point3 boundary settings!
Posted Jan 31, 2012, 4:44 a.m. EST Low-Frequency Electromagnetics, Geometry Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
I am using Comsol 3.5a with matlab, I am creating in graphic interface a Point3 and when I want to set the boundary of that point is imposible to put any. The point is created in a 3D geometry and the 3D geometry is a single entity... for the points of this geometry there is no problem to set values but the extra point created does not give this option. Is it the license? I really appreciate any answer...
1 Reply Last Post Jan 31, 2012, 8:58 a.m. EST
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it might be that your point (if I understand you add it to a closed contour) is not considered by COMSOL as belonging to the polyline. You might need to split and combine or convert the polyline + the point into a higher order element. Check the doc, 3.5 is getting old for me ;)
--
Good luck
Ivar
it might be that your point (if I understand you add it to a closed contour) is not considered by COMSOL as belonging to the polyline. You might need to split and combine or convert the polyline + the point into a higher order element. Check the doc, 3.5 is getting old for me ;)
--
Good luck
Ivar