Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Model shape change over time

Please login with a confirmed email address before reporting spam

Dear all,

I would like to simulate the temperature entry during laser drilling of a microsieve in Comsol. Is it possible that after drilling a hole, the created hole is included in the model form? So that there is no more material at this point.

Best regards Marcel


0 Replies Last Post May 7, 2020, 4:57 a.m. EDT
COMSOL Moderator

Hello Marcel Jung

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.