Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

microwave heating(waveguide)

Posted May 4, 2012, 10:48 p.m. EDT Version 4.0 2 Replies

Ma Jun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

In microwave heating, I want to use port boundary condition, how can I calculate incident electric?
(I known input power, and frequency.)

Thank you!
2 Replies Last Post May 18, 2012, 8:42 p.m. EDT
SOhan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago May 18, 2012, 12:13 p.m. EDT
If the port is rectangular you can slectect TE 01 mode and just plug in input power.
If the port is rectangular you can slectect TE 01 mode and just plug in input power.
Ma Jun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago May 18, 2012, 8:42 p.m. EDT
Thank you for your reply.
but I selected rectangular and TE10mode, equation is wrong.
That is my model is wrong?or?
Thank you for your reply. but I selected rectangular and TE10mode, equation is wrong. That is my model is wrong?or?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content