Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Diagnosing poor mesh locations with residual plots

Please login with a confirmed email address before reporting spam

Hello,

I would like to plot the residuals in my domain either after a failed run (after it has reached the maximum number of iterations), after manually canceling a run, or every few iterations in order to see where in the domain the residuals tend to be highest. Is there a way to do this?

So far, I have only been able to view such residual plots after successful runs.

Best, HL


0 Replies Last Post Jun 29, 2021, 11:21 p.m. EDT
COMSOL Moderator

Hello HL

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.