Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modelling a golf shaft

Please login with a confirmed email address before reporting spam

Hi Everyone,

i am new to COMSOL, i am trying to model a golf swing using a tappered shaft (ideally) otherwise just a plain ordinary hollow beam of dimensions 0.8m by 0.02, in a 2D space, and then devloping to 3D.

What i am struggling to get is a beam of the dimensions above, to take some point load or angular velocity, which causes it to rotate through 90 degrees. With a mass (clubhead) of 200g on one end of the beam, i am struggling to get it fixed at one end and apply a torque or load. If someone could help that would be fantastic !! Many thanks In advance


0 Replies Last Post Nov 5, 2021, 3:20 p.m. EDT
COMSOL Moderator

Hello Sebastian Bramah

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.