Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Magnetic flux density

Posted Jul 11, 2012, 5:22 a.m. EDT Version 4.2a 2 Replies

kishore naik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

in the model attached i excited the coil by single turn coil domain , but i am getting only the magnetic flux density on first coil only , not reaching the second coil can any one pls solve the problem , i am not bale to attach the model as it is very high size

--
kishore Naik Mude
2 Replies Last Post May 8, 2013, 2:14 p.m. EDT
COMSOL Moderator

Hello kishore naik

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Vahid Babakeshizadeh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago May 8, 2013, 1:54 p.m. EDT
Hi

there is no model attached!

Delete the solver and the solution and attach a clean file. Solution needs a lot of memory but not the model, usually!


Otherwise, no one can help!
Hi there is no model attached! Delete the solver and the solution and attach a clean file. Solution needs a lot of memory but not the model, usually! Otherwise, no one can help!
Dan Jia
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago May 8, 2013, 2:14 p.m. EDT
You may click "edit", then choose "clear mesh", "clear result". The size of file will be smaller enough to upload.
You may click "edit", then choose "clear mesh", "clear result". The size of file will be smaller enough to upload.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content