Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary showing "not applicable"

Posted May 20, 2022, 2:02 a.m. EDT Electromagnetics, Low-Frequency Electromagnetics, Geometry Version 5.5 0 Replies

Divya Prakash
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am building a square spiral inductor coil. The coil is to be made of copper and surrounded by air medium. I want to add terminal and ground for the study but the boundaries are shown as "not applicable"

I am fairly new to COMSOL and would like to understand how I can mitigate this issue.

Thanks & Regards, DIvya

Attachments:

0 Replies Last Post May 20, 2022, 2:02 a.m. EDT
COMSOL Moderator

Hello Divya Prakash

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content