Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to apply current？

Posted Sep 30, 2022, 7:22 a.m. EDT Electromagnetics, Low-Frequency Electromagnetics Version 5.6 1 Reply

Qian CAO
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I would like to ask how to apply current when two copper contacts are assembled together by extrusion and the voltage of the two contacts is the same? If the voltage of two contacts is set to the same value, will the electric field change when the motion separation is applied later? Thank you for paying attention to my problems. Thank you very much!

1 Reply Last Post Oct 3, 2022, 5:20 a.m. EDT
Acculution ApS Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago Oct 3, 2022, 5:20 a.m. EDT

Sounds like you need to look into moving mesh for this. Maybe a little more detail on the setup can help.

-------------------
René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com
Sounds like you need to look into moving mesh for this. Maybe a little more detail on the setup can help.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content