How do I extrude 1-D variables to 2-D variables?

Please login with a confirmed email address before reporting spam

Lets say that I have the two layers. I have some 1-D variables at the interface of the layers, but for the display, I would like to show the 1-D variable not as a line but 2-D domain (like the bottom layer) underneath the interface (with the same x location).

I think this would not be very difficult but I cant find the way.

Thank you for your help in advance!

Best regards,


1 Reply Last Post Jun 28, 2024, 4:25 p.m. EDT
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 months ago Jun 28, 2024, 4:25 p.m. EDT
Updated: 5 months ago Jun 28, 2024, 4:25 p.m. EDT

Hello Hyeonwoo,

You can use a General Extrusion coupling operator, see Reference Manual, version 6.2, page 391 and following (especially the example at the top of page 394). The manual is accessible through File > Help.

Best, Jeff

-------------------
Jeff Hiller
Hello Hyeonwoo, You can use a General Extrusion coupling operator, see Reference Manual, version 6.2, page 391 and following (especially the example at the top of page 394). The manual is accessible through File > Help. Best, Jeff

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.