Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to draw a rectangle on a 3D cylinder's surface ?

Posted Feb 21, 2013, 9:46 a.m. EST MEMS & Nanotechnology, Fluid & Heat, Heat Transfer & Phase Change, MEMS & Piezoelectric Devices, Geometry, Parameters, Variables, & Functions, Structural Mechanics Version 4.2 1 Reply

Samyuktha Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hey !
we are working on the simulation of MEMS Based pressure sensor for biomedical applications. We are not able to create the heater element which will heat the liquid inside the cylinder. Kindly help us in proceeding with the project.
1 Reply Last Post Feb 21, 2013, 1:11 p.m. EST
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Feb 21, 2013, 1:11 p.m. EST
Check out the following thread and draw a block with cross section of your desired rectangle instead of 2nd cylinder...

www.comsol.com/community/forums/general/thread/34364/

Best regards,
Josh
Check out the following thread and draw a block with cross section of your desired rectangle instead of 2nd cylinder... http://www.comsol.com/community/forums/general/thread/34364/ Best regards, Josh

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content