Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Eigen Frequency Analysis of SAW Devices
Posted Apr 11, 2013, 2:36 a.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.3 0 Replies
Please login with a confirmed email address before reporting spam
I have a problem regarding the Eigen frequency calculation. I solve a simple 3D piezoelectric substrate (Y-Z cut LiNbO3) width of one wavelength (4 um) and depth of 10 wavelengths with periodic conditions and get the Eigen frequency. But when I displace the same geometry in any directions as x by 2 um and solve, it changes its Eigen frequency. Why it is so?? Since I do not change any of the boundary conditions that is used previously, it should give same Eigen frequency.
When I solve same model in 2D, the Eigen frequencies are same even though I displace the geometry in either directions.
Hello Ashish Namdeo
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.