Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Batch Processing sj
Posted May 2, 2013, 10:33 a.m. EDT Structural Mechanics Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Dear Engineers/Scientists
I am trying to simulate time dependent study a diaphragm with piezo actuator fixed from its periphery and want plot Voltage Vs deflection and also frequency Vs deflection simultaneously but it is not possible for simple simulation i have go for batch processing or some other option because it is possible with ansys to write a small code and do it but In comsol i am not able to do it because i just started using comsol due its good capability to couple different field like FSI and electrical and structural etc, I will be wonder if anybody can Help me
I will very thankful
Ikhlaq Ayub
I am trying to simulate time dependent study a diaphragm with piezo actuator fixed from its periphery and want plot Voltage Vs deflection and also frequency Vs deflection simultaneously but it is not possible for simple simulation i have go for batch processing or some other option because it is possible with ansys to write a small code and do it but In comsol i am not able to do it because i just started using comsol due its good capability to couple different field like FSI and electrical and structural etc, I will be wonder if anybody can Help me
I will very thankful
Ikhlaq Ayub
1 Reply Last Post May 2, 2013, 4:35 p.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
Isn't that the parametric sweep condition with 2 parameters you want ?
If so, just check correctly how you want to mix/stock the two parameters, check the help doc
--
Good luck
Ivar
Isn't that the parametric sweep condition with 2 parameters you want ?
If so, just check correctly how you want to mix/stock the two parameters, check the help doc
--
Good luck
Ivar