Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error: Internal error: cannot convert ElemStruct to int.

Please login with a confirmed email address before reporting spam

Hello,
Today I try to run a new Comsol model,and the same error occurs,
Whenever I try to run the study of the model I get the same error as you.
But there are no errors occur when I run other models.

The following feature has encoutered a problem
- Fearture: Compile Equations: Stationary (sol2/st1)
-Error: Internal error: cannot convert ElemStruct to int.
Internal error: cannot convert ElemStruct to int.
- Value: d7
Error in multiphysics compilation.


I have changed the administor and the computer name. But when I run the model again, the error occurs too.
Could anybody help me with this problem?

Thanks!
Tengfei Zheng

0 Replies Last Post May 6, 2013, 2:42 a.m. EDT
COMSOL Moderator

Hello Tengfei Zheng

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.