Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat Flux Boundary Condition

Please login with a confirmed email address before reporting spam

Hi,

I am trying to impose a constant heat flux BC to the common face of two metal blocks. But comsol does not allow me to select that face for this type of BC. In fact, only outer boundaries are accessible. I did the same problem with Ansys Fluent before and it worked pretty well.

Why is that so? Any comment is appreciated.

Best,
Mohammad

0 Replies Last Post May 15, 2013, 12:52 p.m. EDT
COMSOL Moderator

Hello SMHH

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.