Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Solving multiple modules simultaneously.

Please login with a confirmed email address before reporting spam

As the subject states, I am trying to solve two modules simultaneously. The model is of two electrodes with a solution above them.

One module is a partial differential equation in place of electrostatics to simulate an electric field being generated by 2 electrodes and the second is heat transfer via conduction in the solution on top of the electrodes. The problem is that the voltage applied is the source of heat generation so the second module requires it but at the same time, variables such as conductivity and permittivity are temperature dependent.

I have tried solving them together using an initial Temperature but the program results in a failure almost immediately due not being able to solve for variables such as voltage.

Any advice on how to proceed would be greatly appreciated.

1 Reply Last Post Jul 25, 2013, 4:20 a.m. EDT
COMSOL Moderator

Hello Joshua Raveendran

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jul 25, 2013, 4:20 a.m. EDT
Hi Joshua,

I am trying quite similar but I have one more equation (drift diffusion ). In my simulation electrical and thermal conductivity is function of temperature. I am trying to solve this but still I can't couple them together. Have you solved the problem yet?

Regards,
Sanjoy
Hi Joshua, I am trying quite similar but I have one more equation (drift diffusion ). In my simulation electrical and thermal conductivity is function of temperature. I am trying to solve this but still I can't couple them together. Have you solved the problem yet? Regards, Sanjoy

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.