Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with Mesh Swept

Posted Jul 12, 2013, 11:10 a.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Mesh Version 4.3a 0 Replies

Dimas Mihalikis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

There is something I don't get right with the Mesh Swept option.

I used the model "biased_resonator_3d_modes.mph" from the Model Library as a starting point. There they built a mesh on one face of the structure (figure 04) and used the Swept option to mesh all domains by repeating the initial 2D mesh (figure 05).

I tried the same thing (figures 00, 01, 02) but I'm continiously getting an error message (figure 03) when running Swept. The cross section of my structure is constant along the model, so there should be no mismatch issues.

What am I doing wrong? What are the requirements to build a mesh out of a 2D mesh?

Thanks!
0 Replies Last Post Jul 12, 2013, 11:10 a.m. EDT
COMSOL Moderator

Hello Dimas Mihalikis

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content