Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

mutual coupling waveguides

Please login with a confirmed email address before reporting spam

Hi everyone,

I am trying to model two oppositely located waveguides for heating fluids. I am using 4.2, Electromagnetic waves in RF module and non-isothermal module in heat transfer module.
I am trying to simulate whole model in 3D.

I am using following boundary conditions for emw;
Port (for mutual coupling waveguides)
Scattering boundary condition (for inlet and outlet)
Impedance boundary condition (metal boundaries)

When I run the program I had a wrong solution. Because of mutual coupling the waves can interfere each other (I am not exactly sure it is because of that) . But I don´t know what will I do about this. I must use boundary conditions except these boundary conditions or something else?

I couldn´t find any topic about this. Can anyone help me please?

' I attached my model in attachements.



0 Replies Last Post Jul 22, 2013, 7:49 a.m. EDT
COMSOL Moderator

Hello Sezin Tuta

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.