Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Model coupling to 2D to 3D geomety (General Extrusion)

Posted Aug 21, 2013, 11:27 p.m. EDT Fluid & Heat Version 4.3 0 Replies

Ali
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hello all,

I want to do a model coupling of 2D geometry and 3D.
For this i used general extrusion coupling for that.

I want to couple outlet ( along y axis) and inlet boundaries of 3D geometry through general extrusion coupling method. both geometries are of rectangle shapes.

I could not find suitable expressions for x and y in destination map in general extrusion couplings.

can anyone figure out equations of x and y in destination map for general extrusion coupling.??/

i have attached figure with this message.
looking forward for a reply
regards

Ali


Attachments:

0 Replies Last Post Aug 21, 2013, 11:27 p.m. EDT
COMSOL Moderator

Hello Ali

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content