Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Question about layered Plate model in 3D

Posted Nov 7, 2013, 5:45 p.m. EST MEMS & Nanotechnology, Heat Transfer & Phase Change, MEMS & Piezoelectric Devices, Modeling Tools & Definitions, Parameters, Variables, & Functions, Structural Mechanics Version 4.3b 0 Replies

Arthur Chuang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

So, there's a 2D simulation model in the model library, where three layered plates (carrier at bottom, substrate in the middle, and a coating layer on top) experience thermal stress induced by a temperature drop. This model shows the thermal stress distribution on the plates.

Now, my goal is to basically generate the same thing except that it's in 3D. It has all the steps it takes to generate the 2D model. But, I'm pretty new to Comsol. So, I'm wondering if anyone can help me out and briefly guide me through the major steps I should do to create this 3D model.

Thanks a lot in advance for any feedbacks.
0 Replies Last Post Nov 7, 2013, 5:45 p.m. EST
COMSOL Moderator

Hello Arthur Chuang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content