Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

compilation error

Please login with a confirmed email address before reporting spam

Hi,

I ran a conjugate gradient model for determine temperature distribution (time domain). Then I added a structural analysis model (steady state) with last solution from conjugate gradient as input (with deselecting fluid from the analysis). However, I get the following error:

"No sequence specified
Error in multiphysis compilation."

I would appreciate if any one can point me to a potential solution.

Regards,
Susant

1 Reply Last Post Jan 8, 2015, 5:51 a.m. EST
COMSOL Moderator

Hello Susant Patra

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 10 years ago Jan 8, 2015, 5:51 a.m. EST
Hello,

Same problem for spf physic when adding a stationnary study!! First time I saw this kind of problem

Regards julien
Hello, Same problem for spf physic when adding a stationnary study!! First time I saw this kind of problem Regards julien

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.