Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Parameter sweep: Error in multiphysics compilation.
Posted Jul 13, 2014, 2:21 p.m. EDT Electromagnetic Heating, Studies & Solvers 1 Reply
Please login with a confirmed email address before reporting spam
Dear all,
I am currently running a model using Joule heating module. I am sweeping the material size from radius of 1 cm to 5 cm, and trying to see the heating pattern difference. I set the parameter sweep step as (0.1, 0.1, 0.5) but an error shows when computing as: Error in multiphysics compilation.
This message does not provide specific information help with trouble shooting to me. Can anybody tell me what can I try to make a successful computation? Thanks!
I am currently running a model using Joule heating module. I am sweeping the material size from radius of 1 cm to 5 cm, and trying to see the heating pattern difference. I set the parameter sweep step as (0.1, 0.1, 0.5) but an error shows when computing as: Error in multiphysics compilation.
This message does not provide specific information help with trouble shooting to me. Can anybody tell me what can I try to make a successful computation? Thanks!
1 Reply Last Post Jul 13, 2014, 4:22 p.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Yang,
Kindly check in the units of the parameter that you are trying to parametrize. Coz while building the model you might have given mm/cm as the unit and you are intending to go from 0.1 to 0.5 in steps of 0.1.
Kindly check for continuity of units in model.
Regards
Mahesh
Kindly check in the units of the parameter that you are trying to parametrize. Coz while building the model you might have given mm/cm as the unit and you are intending to go from 0.1 to 0.5 in steps of 0.1.
Kindly check for continuity of units in model.
Regards
Mahesh