Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

real circuit model of the turbogenerator in comsol 4.3b

Posted Aug 6, 2014, 8:22 a.m. EDT Low-Frequency Electromagnetics Version 4.3b 0 Replies

Michał Bardian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I'm new user of Comsol and I'm trying to make a 2d model of turbogenerator. My question is can I make a real circuit model with swithes, terminals, nodes, sources, resistors etc just like it is possible to do in Flux or Maxwell? I know that in Comsol there is a mode Electrical Circuit but it will take a lot of time to make a big circuit using this node connections, that i have found there.
Also I know that I can use a SPICE general-purpose circuit simulation, but is there a easier way to make it?

I will be grateful for every help
0 Replies Last Post Aug 6, 2014, 8:22 a.m. EDT
COMSOL Moderator

Hello Michał Bardian

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content