Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Do I need to specify the unit in the parametric sweep
Posted Sep 16, 2014, 5:31 a.m. EDT Parameters, Variables, & Functions, Studies & Solvers Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
Hi
if I have a variable "a" which is specified as 4[µm] in the global parameters section and in the geometry I have specified [µm] to be the default unit. I wish to do a parametric sweep of it, but do I need to specify the [µm] there as well? like
{1, 2, 3, 4, 5, 6, 7, 8}[µm]
Or is it enough to do write
{1, 2, 3, 4, 5, 6, 7, 8}
The reason I'm asking is that I once forgot to specify the [µm] in the sweep once and it looked like the results were resonable.
if I have a variable "a" which is specified as 4[µm] in the global parameters section and in the geometry I have specified [µm] to be the default unit. I wish to do a parametric sweep of it, but do I need to specify the [µm] there as well? like
{1, 2, 3, 4, 5, 6, 7, 8}[µm]
Or is it enough to do write
{1, 2, 3, 4, 5, 6, 7, 8}
The reason I'm asking is that I once forgot to specify the [µm] in the sweep once and it looked like the results were resonable.
1 Reply Last Post Sep 16, 2014, 5:47 a.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I did a global evaluation of the parameter an it turned out that one must specify it like below (otherwise it will be in meters)
{1, 2, 3, 4, 5, 6, 7, 8}[µm]
{1, 2, 3, 4, 5, 6, 7, 8}[µm]