Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Two Phase Fluid Flow Convergence Error half-way into solution

Posted Sep 29, 2014, 12:59 p.m. EDT Fluid & Heat, Microfluidics, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers 0 Replies

Melaku Wol
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

Time dependent solver for Laminar Two-Phase Flow, Level Set crashes half-way through the solution with error message "last time step didn't converge". Do you know what could cause this? The geometry is a simple y-junction. The mesh is user controlled and done by creating distributions (rectangular) and sweeping them.

Thanks
0 Replies Last Post Sep 29, 2014, 12:59 p.m. EDT
COMSOL Moderator

Hello Melaku Wol

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content